VOLTRONIC AC22 + E20 Bundling Set

VOLTRONIC ® AC22 Air-condition Cleaner and Disinfectant is high performance air-condition cleaner and disinfectant. Removes dirt, eliminate bad odor (eg. nicotine, rotten egg smell), eliminate germs and bacteria. Improves air-condition efficiency and long lasting effect.

Features:

Simply application, clean and disinfectant in one action.

Eliminate bad odors i.e. nicotine, sweat, pets, rotten egg and etc.

Eliminate germs and bacteria.

Non-allergic product.

Improves air-condition cooling efficiency.

Long lasting consistent effect.

Wide application area.

Usage direction:

Removes cabin filter or pollen filter.

Start engine idle, close all windows.

Turn on air-con blower only (AC-OFF) fan at highest speed.

Turn on CIRCULATION mode.

Press trigger valve and place to the nearest air suction inlet.

Use 2 bottles if there are 2 air suction inlet.

Close all doors, do not stay in the car during application.

Allow to wait until the product canister completely discharge.

Install back cabin filter or pollen filter, replace if necessary.

VOLTRONIC ® E20 Engine Flush is advanced internal engine cleaner and oil system cleaner. Formulated with extremely low-ash material, EURO-6 ready. Remove harmful deposit such as carbon deposit on piston and piston ring crapper, oil sludge, dirt aggregate and breakdown particles. With corrosion inhibitor neutralize acidity in the engine. Improve engine performance by restoring engine compression up to 99%. Does not contain aggressive cleaning material, friendly to seal material such as silicone, NBR, SNBR, AEM, ACM and FKM.

Features:

Remove harmful deposit such as carbon deposit on piston and piston ring crapper, oil sludge, dirt aggregate and breakdown particles. Remove oil sludge, contamination, dirt aggregate and breakdown particles, prevent engine from premature wear, and prolong engine life. Improve engine performance by restore engine compression, restore combustion quality, restore fuel economy and reduce emission. Engine compression test before and after engine flush. Formulated with extremely low-ash materials, EURO-6 ready. Does not contain aggressive cleaning material, friendly to seal material such as silicone, NBR, SNBR, AEM, ACM and FKM. Formulated with corrosion inhibitor, neutralize acidity. Clean hydraulic tappet, reduce and eliminate tappet noise.

Usage Direction:

One bottle effectively treat 3 to 5 litres motor oil. Add into engine oil prior oil change interval. Drive normally for approx. 400 km or run engine stationary and give throttle intermittently for approximately 20 minutes. Drain, replace the motor oil and oil filter.

Made in Germany